KRF-V7020-6020-5020.pdf

(752 KB) Pobierz
KRF-V7020/V6020/V5020 (En/T)
1
AUDIO VIDEO SURROUND RECEIVER
KRF-V7020
KRF-V6020
KRF-V5020
INSTRUCTION MANUAL
KENWOOD CORPORATION
This instruction manual is for some models.
Model availability and features (functions) may differ depending on the country and sales area.
About the supplied remote control (RC-R0508) . . .
Compared to standard remote controls, the remote control supplied with this receiver has several
operation modes. These modes enable the remote control to control other audio/video components. In
order to effectively use the remote control it is important to read the operating instructions and obtain a
proper understanding of the remote control and how to switch its operation modes (etc.).
Using the remote control without completely understanding its design and how to switch the operation
modes may result in incorrect operations.
B60-4155-00 02 MA (T,E2,Q)
OC
9809
Remote Control
Other
Operations
Preparation
Getting started
2
Before applying the power
Units are designed for operation as follows.
U.K. and Europe ............................................... AC 230 V only
Russia ............................................................... AC 220 V only
Caution : Read this page carefully to ensure safe
operation.
KRF-V7020/V6020/V5020 (En/T)
Unpacking
Unpack the unit carefully and make sure that all accessories are put
aside so they will not be lost.
Examine the unit for any possibility of shipping damage. If your unit is
damaged or fails to operate, notify your dealer immediately. If your unit
was shipped to you directly, notify the shipping company without
delay. Only the consignee (the person or company receiving the unit)
can file a claim against the carrier for shipping damage.
We recommend that you retain the original carton and packing mate-
rials for use should you transport or ship the unit in the future.
Keep this manual handy for future reference.
For the United Kingdom
Preparations
Operations
Other
Factory fitted moulded mains plug
1. The mains plug contains a fuse. For replacement, use only a 13-
Amp ASTA-approved (BS1362) fuse.
2. The fuse cover must be refitted when replacing the fuse in the
moulded plug.
3. Do not cut off the mains plug from this equipment. If the plug fitted
is not suitable for the power points in your home or the cable is too
short to reach a power point, then obtain an appropriate safety
approved extension lead or adapter, or consult your dealer.
If nonetheless the mains plug is cut off, remove the fuse and
dispose of the plug immediately, to avoid a possible shock hazard
by inadvertent connection to the mains supply.
Accessories
FM indoor antenna (1)
IMPORTANT
The wires in the mains lead are coloured in accordance with the
following code:
Blue
: Neutral
Brown : Live
Do not connect those leads to the earth terminal of a three-pin
plug.
AM loop antenna (1)
Loop antenna stand (1)
REQUIREMENT BY NEDERLAND GAZETTE
Batteries are supplied with this product. When
they empty, you should not throw away. Instead,
hand them in as small chemical waste.
For KRF-V7020, KRF-V6020
Batteries (R03/AAA) (4)
Remote control unit (1)
RC-R0508
Safety precautions
WARNING :
TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOIS-
TURE.
For KRF-V5020
Remote control unit (1)
RC-R0710
Batteries (R06/AA) (2)
Cleaning
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Do not use volatile solvents such as alcohol, paint thinner, gasoline,
or benzine, etc. to clean the cabinet. Use a clean dry cloth.
Do not use contact cleaners because it could cause a malfunction.
Be specially careful against contact cleaners containing oil, for they
may deform the plastic components.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS
INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL,
WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO
ALERT THE USER TO THE PRESENCE OF UNINSULATED
“DANGEROUS VOLTAGE” WITHIN THE PRODUCT’S EN-
CLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE
TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PER-
SONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRI-
ANGLE IS INTENDED TO ALERT THE USER TO THE PRES-
ENCE OF IMPORTANT OPERATING AND MAINTENANCE
(SERVICING) INSTRUCTIONS IN THE LITERATURE AC-
COMPANYING THE APPLIANCE.
Getting started
KRF-V7020/V6020/V5020 (En/T)
Contents
Caution : Read the pages marked
safe operation.
carefully to ensure
3
Getting started ................................... 2
Before applying the power .................................. 2
Safety precautions ............................................... 2
Unpacking ............................................................ 2
How to use this manual ........................................ 4
Special features ................................................... 4
Names and functions of parts ................. 5
Setting up the system ........................... 8
Preparations
Connecting audio components ........................... 8
Connecting video components ............................ 9
Connecting DVD 6-channel jack ......................... 9
Connecting the antennas ..................................... 9
Connecting the system control .......................... 10
Connecting the speakers ................................... 11
Preparing the remote control (RC-R0508) ......... 12
Preparing the remote control (RC-R0710) ......... 13
Preparing for surround sound ................ 13
Speaker settings ................................................ 13
Normal playback ................................ 14
Operations
Remote Control
Other
Preparing for playback ...................................... 14
Listening to a source component ...................... 15
Adjusting the sound ........................................... 15
Recording ........................................ 16
Recording audio ................................................. 16
Recording video ................................................. 16
Listening to radio broadcasts ................. 17
Tuning (non-RDS) radio stations ....................... 17
Using RDS (Radio Data System) ....................... 17
Using the DISPLAY key ...................................... 18
Presetting RDS stations
(RDS AUTO MEMORY) ...................................... 18
Presetting radio stations manually ..................... 19
Receiving preset stations .................................. 19
Receiving preset stations in order (P.CALL) ..... 19
Tuning by program type (PTY search) .............. 20
Reserving the desired information ..................... 20
Operations
Ambience effects ............................... 22
Surround modes ................................................. 22
Surround play ..................................................... 23
DVD 6-channel playback ................................... 23
Convenient functions ......................................... 24
Other
In case of difficulty ............................. 25
Specifications ................................... 27
Quick start guide ................................. 1
Getting the most from
your remote control ............................. 3
Setup code chart ................................. 7
In case of difficulty ............................. 13
Remote operation of other components .... 14
Remote
Control
(Separate
booklet)
(RC-R0508)
Preparations
Getting started
How to use this manual
Special features
True home theater sound
KRF-V7020/V6020/V5020 (En/T)
4
The manual covers the KRF-V7020, KRF-V6020, and KRF-V5020.
Items such as functions, number of jacks, and remote control details
differ somewhat between these models. To confirm the functions
available on the model you have purchased, refer to the table below.
Model name
KRF-V7020
Remote
Control
Terminal
Preout
This receiver incorporates a wide variety of surround modes to bring
you maximum enjoyment from your video software. Select a surround
mode according to your equipment or the software you are going to
play and enjoy!
™
Speaker out
Front input
Dolby Pro Logic & Dolby 3 Stereo
This surround system reproduces theater-like surround sound from
video software marked
.
The PRO LOGIC mode uses the built-in adaptive matrix circuit to
steer the Left, Center, Right and Surround channel audio signals.
The 3 STEREO mode will redirect the Surround signal to the front left
and right speakers when only the front and center speakers are
used.
RC-R0508 2 systems
(A, B)
RC-R0508 2 systems
(A, B)
RC-R0710 1 system
CENTER,
Equipped
SURROUND, (VIDEO 1)
SUBWOOFER
CENTER,
Not equipped
SURROUND,
SUBWOOFER
SUBWOOFER Not equipped
KRF-V6020
Preparations
KRF-V5020
New DSP surround modes
This manual is divided in to four sections, Preparations, Operations,
Other, and Remote Control.
The DSP (Digital Signal Processor) used for this receiver incorpo-
rates a variety of high quality adjustable sound fields, like "LIVE" and
"HALL". It is compatible with almost any kind of program source.
Preparations
Shows you how to connect your audio and video components to the
receiver and prepare the surround processor.
We've tried to make setting up your system as easy as possible.
However, since this receiver works with all of your audio and video
components, connecting the system can be fairly complex.
DVD 6-channel input
If you own a DVD player equipped with 6-channel output, this
receiver allows you to obtain the full surround sound impact of DVD
source material featuring multi-channel encoding. Since the source
signals are digital and each channel is input independently, the
resulting ambience is far superior to what can be achieved with
conventional surround sound systems.
Operations
Shows you how to operate the various functions available from the
receiver.
Universal IR (InfraRed) remote control (RC-R0508 only)
In addition to the basic receiver, the remote control supplied with this
receiver can also operate almost all of your remote controllable audio
and video components. Just follow the simple setup procedure to
register the components you have connected.
Other
Shows you additional information such as “In case of difficulty” (trouble-
shooting) and “Specifications.”
Remote Control (Separate booklet) (RC-R0508 only)
Includes the “Quick Start Guide,” which shows you how to operate
other components using the remote control, as well as a detailed
explanation of all remote control operations. Once you have registered
your components with the proper setup codes, you’ll be able to operate
both this receiver and your other AV components (TV, VCR, LD player,
CD player, etc.) using the remote control supplied with this receiver.
MACRO play (RC-R0508 only)
The MACRO function lets you perform a series of operations auto-
matically, like turning ON the power of the receiver and connected
components, switching the input selectors, and starting playback.
(Be sure to register your components before starting the macro set
up procedure.
RDS (Radio Data System) tuner
The receiver is equipped with a RDS tuner that provides several
convenient tuning functions: RDS Auto Memory, to automatically pre-
set up to 30 RDS stations broadcasting different programs; station
name display, to show you the name of the current broadcast station;
and PTY search to let you tune stations by program type.
PTY (Program TYpe) search
Lets you tune stations by specifying the type of program you want to
hear.
EON (Enhanced Other Networks) reservation
The EON function lets you monitor information on other stations so
you can receive traffic or news programs as soon as they are
broadcast, even they are broadcast on a station different from the
one you are currently listening to. When the broadcast ends, the
receiver returns to the original station. When listening to KENWOOD
source components connected with system control cords, the input
selector on the receiver automatically switches to the tuner when a
program you desire is broadcast.
Names and functions of parts
KRF-V7020/V6020/V5020 (En/T)
TI.VOL indicator
For KRF-V5020
Speaker indicator
MUTE indicator
SP
SP
Frequency display,
Input display,
Preset channel display,
Surround mode display
PRO LOGIC
indicator
Band indicators
FM
MHz
3 STEREO
MONITOR
kHz
DOWNMIX
DSP
5
AUTO indicator
MEMO. indicator
ST. indicator
S.DIRECT indicator
AUTO
ST.
TUNED
A B
TI.VOL
L
C
R
SW
MUTE
RDS EON PTY
LS
TP TA NEWS
S
RS
*
**** *;**
Display
AM
PRO LOGIC
S.DIRECT
MEMO.
Speaker selection indicators
Output channel indicators
1
2
3
45 6 7
8
9
AV SURROUND RECEIVER
VOLUME CONTROL
STANDBY
PTY
TA/NEWS
DISPLAY
BAND
AUTO
MEMORY
MULTI CONTROL
INPUT SELECTOR
ON / STANDBY
-
ON
POWER
SPEAKERS
A
B
BASS BOOST
–
OFF
VIDEO 2/
MONITOR
SOURCE
DIRECT
LISTEN MODE
SOUND
SETUP
PHONES
DOWN
VIDEO 1
UP
VIDEO
L—AUDIO—R
FRONT
REAR
0
For KRF-V5020
! @ # $ %
SPEAKERS
MUTE
^ & *
(
)
¡
™
For KRF-V7020
1
POWER key
$
Use to turn the main power ON/OFF.
) key
$
2
ON/STANDBY (
Use to switch the power ON/STANDBY
when the POWER is turned ON.
STANDBY indicator
3
PTY key
Use to perform PTY search.
4
TA/NEWS key
)
5
DISPLAY key
*
Use to change the display indications when
receiving RDS broadcasts.
6
BAND key
&
Use to select the broadcast band.
7
AUTO key
&
Use to select the auto tuning mode.
8
MEMORY key
*
Use to store radio stations in the preset
memory.
9
VOLUME CONTROL knob
%
0
PHONES jack
^
Use for headphone listening.
!
SPEAKERS A key
$
Use to turn speaker system A on and off.
SPEAKERS key (KRF-V5020)
$
Use to turn the speakers on and off.
@
SPEAKERS B key
$
Use to turn speaker system B on and off.
MUTE key (KRF-V5020)
^
Use to temporarily mute the sound.
#
BASS BOOST key
%
Use to select the maximum adjustment
setting for the low frequency range.
$
VIDEO 2 / MONITOR key
8^
%
SOURCE DIRECT key
^
^
LISTEN MODE key
£
Use to select the listening mode.
&
SOUND key
¢
Use to adjust the sound quality and ambi-
ence effects.
*
SETUP key
#
Use to select the surround sound settings.
(
MULTI CONTROL knob
Used to make a variety of settings.
)
INPUT SELECTOR knob
%
Use to select the input sources.
¡
VIDEO 1 input jacks
(For KRF-V7020)
™
FRONT/REAR key
Use to select FRONT or REAR for the VIDEO 1
input.
About the STANDBY indicator
This unit has a STANDBY indicator. When the STANDBY indicator is lit, the unit consumes a small amount of power to preserve the memory. This is called
STANDBY mode. This mode also lets you turn the power ON using the remote control.
Preparation
RDS indicator
TUNED indicator
MONITOR indicator
DSP indicator
3 STEREO indicator
STEREO indicator

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin