FANUC Fapt Ladder III - Operator's Manual.pdf

(5351 KB) Pobierz
OPERATOR’S MANUAL
B-66234EN/03
No part of this manual may be reproduced in any form.
All specifications and designs are subject to change without notice.
The export of this product is subject to the authorization of the
government of the country from where the product is exported.
In this manual we have tried as much as possible to describe all the
various matters.
However, we cannot describe all the matters which must not be done,
or which cannot be done, because there are so many possibilities.
Therefore, matters which are not especially described as possible in
this manual should be regarded as ”impossible”.
B-66234EN/03
SAFETY PRECAUTIONS
SAFETY PRECAUTIONS
This manual includes safety precautions for protecting the user and
preventing damage to the
machine. Precautions are classified into Warnings and Cautions
according to their bearing on
safety. Also, supplementary information is described as Notes. Read
the Warnings, Cautions,
and Notes thoroughly before attempting to use the machine.
WARNING
Applied when there is a danger of the user being
injured or when there is a danger of both the user
being injured and the equipment being damaged if
the approved procedure is not observed.
CAUTION
Applied when there is a danger of the equipment
being damaged, if the approved procedure is not
observed.
NOTE
Notes is used to indicate supplementary information
other than Warnings and Cautions.
- Read this manual carefully, and store it in a safe place.
s-1
SAFETY PRECAUTIONS
B-66234EN/03
GENERAL WARNINGS AND CAUTIONS
The following warnings and note describe precautions on handling
CNCs, which must be observed to ensure safety when using machines
equipped with a CNC.
WARNING
1 Before operating the machine, thoroughly check the
entered data. Operating the machine with incorrectly
specified data may result in the machine behaving
unexpectedly, possibly causing damage to the
workpiece and/or machine itself, or injury to the user.
2 The parameters for the CNC and PMC are factory-
set. Usually, there is no need to change them.
When, however, there is no alternative other than to
change a parameter, ensure that you fully Failure to
set a parameter correctly may result in the machine
behaving unexpectedly, possibly causing damage to
the workpiece and/or machine itself, or injury to the
user.
NOTE
Command programs, parameters, and variables are
stored in nonvolatile memory in the CNC. Generally,
the contents of memory are not lost by a power
on/off operation. However, the contents of memory
may be erased by mistake, or important data in
nonvolatile memory may have to be erased upon
recovering from a failure.
To enable the restoration of data as soon as possible
if such a situation arises, always make a backup of
the data in advance.
s-2
B-66234EN/03
SAFETY PRECAUTIONS
WARNINGS AND NOTES RELATING TO FAPT LADDER-III
Warnings and notes relating to FAPT LADDER-III appear in this
manual. Before using the software, read this manual thoroughly and
take time to read the Warnings, Cautions, and Notes in this manual
carefully.
In addition, "READ THE FOLLOWING:" which appears in the next
section, summarizes the note to be kept in mind when FAPT
LADDER-III is used, which is not described in the chapters in this
manual. Before using this software, also read this part.
s-3

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin